AmpliPHI Sol-Ark Integration Guide

SimpliPhi Power, Inc. | 3100 Camino Del Sol | Oxnard, CA 93030, USA | [phone] | [e-mail] | SimpliPhiPower.com
|
4
|
© SIMPLIPHI POWER
1.0 – Introduction
This integration guide covers the recommended set up and configuration of Sol-Ark equipment for optimizing
performance with SimpliPhi’s AmpliPHI batteries.
CAUTION: THIS INTEGRATION GUIDE IS RELEVANT TO AMPLIPHI BATTERIES ONLY.
REFER TO THE SOL-ARK INTEGRATION GUIDE FOR SIMPLIPHI POWER PHI BATTERIES,
LINKED HERE, FOR APPLICATIONS USING CORE POWER PHI BATTERIES THAT DO
NOT INCLUDE A NETWORKING COMMUNICATIONS PORT.
More information on SimpliPhi products can be found on our website at https://simpliphipower.com/. All
SimpliPhi Product Documentation can be found at https://simpliphipower.com/product-documentation/. More
information regarding Sol-Ark’s products can be found at https://www.sol-ark.com.
The Sol-Ark products covered in this guide are the Sol-Ark-8K and the Sol-Ark-12K-P. Limiter sensors
referenced in this Guide are included with a purchase of Sol-Ark equipment. Sol-Ark equipment includes a built-
in transfer switch but not a critical loads panel.
Contact SimpliPhi Power Technical Support (805-640-6700; [e-mail]) regarding any
compatibility questions for products not listed in this guide.
2.0 – Battery Bank-to-Inverter Connection
Wire the AmpliPHI Battery bank to the Sol-Ark according to the AmpliPHI Battery Installation Manual
[
https://simpliphipower.com/wp-content/uploads/documentation/ampliphi-series/simpliphi-power-ampliphi-
3-8-installation-manual.pdf], not according to the Sol-Ark Manual:
Figure 1: Solar-Ark to Battery Connection
REV202105181844