AmpliPHI 3.8kWh Battery Installation Manual
Table Of Contents
- 1.0 – Introduction
- 1.1 – Online Resources
- 2.0 –Safety
- 3.0 – Pre-Installation
- 4.0 – Installation
- 5.0 – Programming
- 6.0 – Troubleshooting
- Appendix A – AmpliPHI Battery Safety & Green Attributes, Certifications
- Appendix B – AmpliPHI Approved External Chargers
SimpliPhi Power, Inc. | 3100 Camino Del Sol | Oxnard, CA 93030, USA | (805) 640-6700 | info@simpliphipower.com | SimpliPhiPower.com
| 28 |
© SIMPLIPHI POWER
the market today – no fumes, leaking, or gas discharge and no chemicals or acids to worry about. Designed and
Manufactured in the USA Using Exclusive American Patented Technologies.
Appendix B – AmpliPHI Approved External
Chargers
This Appendix section covers the AmpliPHI Battery’s approved external / plug-in chargers.Typically, ancillary
charging of SimpliPhi’s batteries is not required, and charging using any of the charge controllers and/or
inverter/chargers listed in the “Integration Guides” section of the SimpliPhi web site’s Product Documentation
page is acceptable. However, ancillary charging may be necessary in the following situations:
1. No charge controller or inverter/charger is available
2. Increasing the battery’s State of Charge (SoC) after an extended storage period and prior to
installation
3. For recharge purposes when the battery’s voltage is below the minimum required voltage for charge
controller and/or inverter/charger equipment to turn on
B.1 – Recommended 48V Charger
The 54.6V 4A 13 Series 48V LiFePO4 Smart Charger from WAOUKS is recommended and available online for
purchase at this link
.
The 58.4V 5A 16 Series 48V LiFePO4 Smart Charger from WAOUKS is recommended and available online for
purchase at this link
.
The 48V/30A for LiFePO4 / LiFeYPO4 (58.8V) + GMS charger from GWL/Power is recommended and
available for online purchase at this link
.
The Smart Charger (15A) for 51.2V (16 cells) LiFePO4 Battery Pack – CH-PFC51215A charger from AA
Portable Power Corp is available online for purchase at this link
.
When placing your order, specify the connection type to match your battery model. PHI 3.8 batteries require a
charger with alligator clips or crocodile clips.
B.2 – Alternative Chargers
If the above listed chargers are unavailable or undeliverable to your specific location, SimpliPhi also approves of
Iota Engineering’s battery chargers (link here) to increase the AmpliPHI battery’s voltage. These chargers
should only be used in order to increase battery voltage enough to regain system operability; these chargers
should not be used to regularly and fully charge the AmpliPHI battery.
REV202203161200