AmpliPHI 3.8kWh Battery Installation Manual
Table Of Contents
- 1.0 – Introduction
- 1.1 – Online Resources
- 2.0 –Safety
- 3.0 – Pre-Installation
- 4.0 – Installation
- 5.0 – Programming
- 6.0 – Troubleshooting
- Appendix A – AmpliPHI Battery Safety & Green Attributes, Certifications
- Appendix B – AmpliPHI Approved External Chargers
SimpliPhi Power, Inc. | 3100 Camino Del Sol | Oxnard, CA 93030, USA | (805) 640-6700 | info@simpliphipower.com | SimpliPhiPower.com
| 20 |
© SIMPLIPHI POWER
In a string of batteries, the two batteries at the ends of the communication chain will have a cable occupying
only one of the “daisy-chaining” ports in the AmpliPHI battery. On each of these two batteries, the
communication port not occupied by a cable will need a 120Ohm terminator plug installed in the open port (see
photo). One terminator plug is included per AmpliPHI battery.
Figure 11.0 – AmpliPHI Batteries Networked Together in a Daisy-Chain
Figure 12.0 – AmpliPHI Batteries Networked
Terminator plugs at
the head and tail of
the daisy chain
REV202203161200