AmpliPHI 3.8kWh Battery Installation Manual
Table Of Contents
- 1.0 – Introduction
- 1.1 – Online Resources
- 2.0 –Safety
- 3.0 – Pre-Installation
- 4.0 – Installation
- 5.0 – Programming
- 6.0 – Troubleshooting
- Appendix A – AmpliPHI Battery Safety & Green Attributes, Certifications
- Appendix B – AmpliPHI Approved External Chargers
SimpliPhi Power, Inc. | 3100 Camino Del Sol | Oxnard, CA 93030, USA | (805) 640-6700 | info@simpliphipower.com | SimpliPhiPower.com
| 17 |
© SIM
PLIPHI POWER
Figure 7.0 – Cable Lug Wiring onto AmpliPHI Threaded Stud
CAUTION: No material (such as a washer) should be placed between the current carrying
terminal and the cable lug or interconnecting busbar.
Doing so will Void the Warranty.
CAUTION: Sparks may be present when connecting wires to AmpliPHI Battery terminals.
Be sure the battery’s built-in circuit breaker is in the OFF position to minimize the risk of
shock or sparks during system installation.
4.6.3 – Parallel Wiring Batteries with Threaded Studs using
Interconnecting Busbars
AmpliPHI Batteries can be paralleled using common bussing directly attached to the batteries’ terminals.
Interconnecting busbars for paralleling either two (SKU #BB-2) or three (SKU #BB-3) AmpliPHI batteries with
threaded studs are available from SimpliPhi at an additional cost.
REV202203161200
CAUTION: Using an impact driver or power tools on the terminals will Void the Warranty.
Using power tools or impact drivers may damage the terminal even if it doesn’t result in
breakage. Only use accurately calibrated and properly adjusted torque wrenches when
tightening terminal hardware.