AmpliPHI 3.8kWh Battery Installation Manual
Table Of Contents
- 1.0 – Introduction
- 1.1 – Online Resources
- 2.0 –Safety
- 3.0 – Pre-Installation
- 4.0 – Installation
- 5.0 – Programming
- 6.0 – Troubleshooting
- Appendix A – AmpliPHI Battery Safety & Green Attributes, Certifications
- Appendix B – AmpliPHI Approved External Chargers
SimpliPhi Power, Inc. | 3100 Camino Del Sol | Oxnard, CA 93030, USA | (805) 640-6700 | info@simpliphipower.com | SimpliPhiPower.com
| 15 |
© SIMPLIPHI POWER
Figure 5.0 – Incorrect AmpliPHI Wiring
All wire lengths from each AmpliPHI Battery to common busbars or plates should be identical in length and
gauge in order to balance the load across (all) AmpliPHI Batteries in the installation
.
CAUTION: Identical wire lengths and identical wire gauges from each AmpliPHI Battery in
an AmpliPHI Battery bank is a critical feature of parallel power storage systems that must
be adhered to throughout all parallel wiring instructions. Failure to properly wire the
AmpliPHI Batteries in parallel will Void the Warranty.
Figure 5.0 depicts three AmpliPHI Batteries wired in Parallel to a terminal block. This configuration
requires 8 identical lengths of identical gauge copper wire.
Figure 6.0 - Four PHI Batteries in Parallel
REV202203161200