AmpliPHI 3.8kWh Battery Installation Manual
Table Of Contents
- 1.0 – Introduction
- 1.1 – Online Resources
- 2.0 –Safety
- 3.0 – Pre-Installation
- 4.0 – Installation
- 5.0 – Programming
- 6.0 – Troubleshooting
- Appendix A – AmpliPHI Battery Safety & Green Attributes, Certifications
- Appendix B – AmpliPHI Approved External Chargers
SimpliPhi Power, Inc. | 3100 Camino Del Sol | Oxnard, CA 93030, USA | (805) 640-6700 | info@simpliphipower.com | SimpliPhiPower.com
| 14 |
© SI
MPLIPHI POWER
4.6.2 – Parallel Wiring Batteries with Threaded Studs using Battery
Cables
AmpliPHI Batteries are paralleled by wiring from individual AmpliPHI Batteries to DC busbars or
plates, which may be located in a DC combiner box or the inverter’s power panel.
Figure 4
.0 – Two AmpliPHI Batteries in Parallel
Althou
gh lead acid batteries are typically wired using battery-to-battery interconnecting cables, SimpliPhi
asks that AmpliPHI Batteries NOT be wired in this way (in series).
REV202203161200