Owner`s manual

SimpliFire • SF-WM36 • 2040-902 Rev. F • 1/14

Figure 4.6 Installing Anchors in Hollow Wall

Figure 4.4 3/16 Toggle-Bolt Anchor

• Four 3/16 toggle-bolt anchors are provided to ac-

comodate four of the six required anchor points. Use

of toggle bolt anchors requires drywall thickness of

minimum 1/2 in.

• Insert the bolt through the front side of the mounting

bracket and thread the toggle onto it from the rear of

the bracket. See Figure 4.5.

• Fold the toggle wings ﬂ ush against the bolt and push

them through a drilled hole until they expand open

on the other side. See Figure 4.6.

• Pull back on the bolt and tighten. See Figure 4.4.

Note: This product cannot be installed on a wall

sheathed with drywall less than 1/2 in. thick, unless

all six anchor points in the mounting bracket align

with structural framing members.

WARNING! Risk of Damage or Personal Injury! Al-

lowable pull-out and shear strength are 25% of ultimate

values or less, as required by building authorities.

Framed Wall

• For each of the marked anchor point locations, de-

termine which points align with a structural framing

member.

• At the points where a wood or metal framing mem-

ber exists, the 5 x 40 screw can be installed directly

into that structural member. See Figure 4.3.

• Every mounting hole that does not align with a

structural framing member, a wall board toggle-bolt

anchor must be used. See Figure 4.4.

Figure 4.5 Toggle Bolt Installation through Mounting Bracket

C. Appliance Installation

• Hang appliance on the mounting bracket.

• Align the slots on the back of the appliance with the

hooks on the top two corners of the bracket.

• Hang the appliance and pull down to ensure the hooks

are fully engaged. See Figure 4.7.

• Secure the appliance to the bracket with two M5x10

screws. See Figure 4.7.

Secure with screw on each

side of appliance.

Figure 4.7 Attaching Fireplace to Bracket

Mounting Hooks

Point Up