Owner`s manual

SimpliFire • SF-WM36 • 2040-902 Rev. F • 1/14
12
B. Operating by Remote Control
• The fireplace Main Power Switch must be in the
“ON”position for the remote control to function.
• Make sure batteries are properly installed in Remote
Control.
- Battery requirements CR2032 battery (included).
• The effective range of the remote is up to 13 ft.
• The remote control must be within the 13 ft. range and
also be pointed directly at the face of the appliance.
For best results, position the remote control within 45
degrees of the face of the appliance
TITLE FUNCTION
POWER
The POWER button will turn the fi replace on. It will also
put the fi replace in a standby mode. This will turn off all
functions at once but will hold the settings in memory except
Heater function. The unit will turn on at the same settings by
pressing the power button again.
FLAME
By pressing the FLAME button, the unit will cycle through
three fl ame effects.
BACKLIGHT
Pressing the button turns the fi rebox backlight through three
lighting effects.
LOW
Press once to turn heater on low. Press again to turn heater
off.
HIGH
Press once to turn heater on high. Press again to turn
heater off.
POWER
FLAME
LOW
BACKLIGHT
HIGH
C. Resetting Temperature Cutoff Switch
The heater is protected with a safety device to prevent
overheating. Should the heater overheat, an auto-
matic cutoff will turn the heater OFF. It will not turn ON
automatically without being reset. If it overheats for any
reason, it can be reset by:
1. Turn fi replace to off
2. Unplug unit and wait 5 minutes
3. Plug in and turn on.
CAUTION: If appliance overheats repeatedly, discon-
tinue use and call customer / technical support.
CAUTION: If you need to continuously reset the heater,
unplug the appliance and call customer / technical sup-
port.