Owner`s manual

SimpliFire • SF-PP23-E, SF-PP26-E • 2040-901 Rev. D • 10/13

A. Installation into Cabinet

1. Locate the securing hardware and mounting brackets.

See Figure 4.1.

2. Lift ﬁ replace into the rear of the ﬁ nished mantel and slide

forward into opening. See Figure 4.2

NOTICE: After installation, ensure there is a minimum of

six square inches of

ventilation area between inside and

outside of fireplace mantel. This is required for blower

make-up air.

Figure 4.2 Installing Fireplace

3. Secure the ﬁ replace into ﬁ nished mantel by installing

brackets. Line up holes in brackets with holes in

mantel and secure each side with two screws.

See Figure 4.3.

Figure 4.3 Securing Fireplace

4. Place ﬁ replace in desired location. Plug into outlet.

See plug-in / outlet grounded view shown in Figure

4.4.

Figure 4.5 Finished View

Figure 4.4 Grounded Plug-in

WARNING! Risk of Fire! Do not store or use gasoline

or other ﬂ ammable vapors and liquids in the vicinity of the

appliance.

NOTE: Wiring procedures and connections shall be in

accordance with the national and local codes having

jurisdiction.

Figure 4.1 Mounting Hardware

2 - Mounting Brackets

4 - Securing Screws

INSTALLATION

WARNING! Risk of Fire, Electrical Shock and Injury.

Ensure the power cord is not installed so that it is pinched

or against a sharp edge and ensure that the power cord is

stored or secure to avoid tripping and snagging.

Note: Slight gap may

exist between glass

edge and glass frame.