Owner`s manual

SimpliFire • SF-BI30-E, SF-BI36-E • 2040-900 Rev. C • 2/13

WARNING! Donotoperatetheunitifitisdamagedorhas

malfunctioned.Ifyoususpecttheunitisdamaged,call

aqualiedservicetechniciantoinspectandreplaceany

partoftheelectricalsystemifnecessary.

Note: A harmless slight brief odor may occur during rst

use or after prolonged period of storage.

A. Manual Switch Function:

The appliance can be operated by both remote control

and manual button. Once the unit has been properly

connected to a grounded electrical circuit, the unit can

be turned ON by pressing the Flame button. In any ac-

tive Flame mode, the Heater button function is available.

If the Flame effect is OFF, there is no Heater button

function. See Figure 5.1.

Flame Button

By pressing the FLAME button, the unit will cycle

through four ame effects.

Heater Button

- Press the heater button once to turn 750W power on.

Appliance will beep and illuminate 1 red LED.

- Press again turns 1500W power on.

Appliance will beep and illuminate 2 red LEDs.

- Press third time turns heater off.

NOTE:

There is a brief delay between the heater command and

the heating turning ON. When the appliance receives

a heater ON command, the appliance blower will turn

ON for 8 seconds before the heater turns ON. There is

also an 8 second delay between heater off and blower

shutdown.

Figure 5.1 Manual Operating Switches

OPERATING INSTRUCTIONS

Flame Button

Heater Button