Owner's Manual

11 / 15
OK: confirm button.
UP/DWON/LEFT/RIGHT button: for OSD value setting.
VOL-/+ decrease or increase audio volume, MIC-/+ is Unused.
5.5 Auto-Switching function
The RPS1 has an auto-switching mode and manual-switching mode. When the user selects
auto-switching mode, it will react as follows:
5.5.1. New input principle
Once a new input signal is detected, the RPS1 will switch to this new signal automatically.
5.5.2. Power rebooting principle
The RPS1 offers the function to remember the signal last used after rebooting. Once
rebooted, it will automatically enter auto-switching mode, and then detect all inputs and
memorize their connection status for future reboots. If the last used input signal is still
available, then it will choose that signal. If not, it will detect all input signals with priority on
HDMI1->HDMI2->HDMI3->HDMI4->VGA(YPbPr/CVBS).
5.5.3.Signal removing principle
Once the current signal is removed, the RPS1 will detect all input signals with priority on
HDMI1->HDMI2->HDMI3->HDMI4->VGA(YPbPr/CVBS). It will transfer the first signal
detected to the output.
Notice: Auto-switching function works only when there is a new input signal or if an input
signal is removed.
5.6 VGA/YPbPr/CVBS input
The VGA input port is a multiple format port, it can accept a VGA, YPbPr, or CVBS input
signal. The RPS1 will auto detect the input signal type and format. A converter cable is
provided for use with YPbPr or CVBS inputs.