Owner's Manual

21
IP: 192.168.1.72
Subnet Mask:
255.255.255.0
Gateway: 192.168.1.1
Mac address:
00:1C:91:03:80:01
Control setting
s autopower z!
Set display auto power on/off control
z=0~1(z=0 disable, z=1 enable)
Display autopower
control enable
r autopower!
Get display auto power state
Display autopower
control enable
s autopower
mode z!
Set display auto power control mode
z=1~3(z=1 RS-232, z=2 CEC, z=3 IR)
Display autopower
control by RS-232
r autopower
mode!
Get display auto power mode
Display autopower
control by RS-232
s autopower on
time y!
Set auto power on timeout y=0~600 seconds
Display autopower on
timeout is 100 seconds
r autopower on
time!
Get auto power on timeout
Display autopower on
timeout is 100
seconds
s autopower off
time y!
Set auto power off timeout y=0~600 seconds
Display autopower off
timeout is 100 seconds
r autopower off
time!
Get auto power off timeout
Display autopower off
timeout is 100
seconds
s cec cmd
(PORT)
(SOURCE+
DESTINATION)
(OPCODE)(ARGS
)
end!
CEC command sending.
(PORT) is 1 byte;
[PORT] =01~02 is hdmi output 1~2;
(SOURCE+DESTINATION) is 1 byte,4~7bit is
[SOURCE],0~3bit is [DESTINATION]
[SOURCE] is command Initiator
LogicAddress,
[DESTINATION] is command Follower
LogicAddress.
[OPCODE] is Operating code for CEC，
[ARGS] is The parameters for the CEC
opcode,
Some of the CEC commands have
parameters
PORT:HAMI OUT 1
SOURCE:05
DESTINATION:0F
OPCODE:82
ARGS:10 00