Owner's Manual

14
■ Control page
The Control page is used to set the RS232 or IR display device power on/off
commands for the Automatic Power Switching mode. When this mode is
enabled, the display power off and power on commands will be sent from
RS232-A/RS232-B or IR-A/IR-B outputs after the defined Power Off Timeout
and Power On Timeout values respectively.
The Control page has three modes: RS232, CEC or IR. Power On and Power
Off commands can only be entered for the RS232 and IR modes. The
CEC mode power on and power off commands are provided by default and
cannot be changed. Only use CEC mode with displays that support CEC
commands.
▪ RS232 Setting 1 and RS232 Setting 2
Select the desired tab and configure the RS232 port settings to match the
display device requirements. Select either ASCII or HEX for the command
format and enter the Power Off and Power On commands with the appropriate
command termination mode: None, CR, LR or CRLF.
If the display device is connected to the respective RS232-A or RS232-B port,
use the Test buttons to confirm that the command is correct. Once the
command is valid, use the Save button to store those commands in the Matrix.
Note that ASCII commands can use any ASCII character, but HEX command
must use hexadecimal notation using hexadecimal value pairs separated by
spaces.