Owner's Manual

12
Copy from OUT 1
Copy from OUT 2
Note that the User 1 and User 2 are global EDID memories only. Any inputs
that is set to one of these memories will always use the same EDID data from
User 1 or User 2 respectively.
This page also provides a means of sending a binary EDID image file to
either User 1 or User 2 EDID memories:
1. Select the binary EDID image file on your PC by click on the Browse button.
2. Select either User 1 or User 2 from the drop-down list.
3. Click the Upload button.
The EDID data from any input or from the User 1 and User 2 locations can
be read and stored on your PC.
■ Output page
The Output page provides information about the signal status of the outputs.
The outputs can also be assigned meaningful names, is desired.
The scaler mode menu provides the following options:
Off
No scaling.
4K→1080P
Downscale to 1080p, if needed.
HDBT Mode
Downscale to no more than 10.2Gbps for HDBaseT
compliance.
Auto
Scale to match the display requirements.
The ARC buttons enable or disable the ARC decoding to the analogue
audio outputs.
The Stream buttons enable or disable the output signal for the respective
output.
The HDCP buttons enable or disable HDCP at the respective HDMI output.