Owner's Manual

9
7. Using the Built-In Web Interface
The RM42C Matrix has a built-in web interface to provide a means of controlling or
configuring various settings. There are seven pages available, each of which
will be outlined in detail in the following sections.
The seven pages are:
1. Status – Displays information about the firmware and IP settings
2. Switch – Control the video routing and enabling the test pattern mode
3. Input – Displays information about the input signals and EDID settings
4. Output – Displays information about the output signals and scaler options
5. Network – Allows basic network setting management and login options
6. System – Serial baud rate, test pattern setting and firmware update
7. Control – Auto Power Control Settings and Commands
Note these seven pages are only accessible in Admin mode, when User mode is used
only the Status and Switch pages are available.
To access the web interface, enter the IP address of the Matrix into
the address bar of any web browser. The factory setting is DHCP. If the IP address is not
known, use the RS232 commands given in the Network Settings section “r ip addr!” to
discover the IP address of the Matrix or use a network scanning tool such as Fing. After
entering the IP address the following log in screen will appear:
Select the Username from the list and enter the password. The default
passwords are:
Username User Admin
Password user admin
After entering the log in details, click the LOGIN button and the following
Status page will appear.