Owner's Manual

Receiver unit
-
©
('.)
•••
c~
®
EQ HDMI Out
IA In
CAT
DCSV
CD EQ switch: HDMI Receiver equalizer switch for optimizing the Rx to the
Cat5E/Cat6 cable length.
@ HDMI out: This connection is for the HDMI cable that runs to your display
such as an HDTV or projector.
® IR in: Connect to the IR Receiver for IR signal reception. Ensure that remote
being used is within the direct line-of-sight of the IR receiver.
© Power LED: This LED will illuminate when the device is connected with
power supply.
® CAT: Connection for the CATSE/6 cable to link the Rx and Tx devices.
@ Lock LED: This LED will illuminate when the HDMI signal from the
transmitter is stable.
(J) DC SV: Connect from SV DC power supply into the unit and connect the
adaptor to an AC outlet. (For POC fuciton, the receiver does not need
power supply).
RX Equalizer distance adjust
If you see flickering or blinking image on the display, adjust the EQ switch to
improve the cable skew. MAX stands for the strongest HDMI signal level for the
longest possible transmission length while MIN stands for the weakest HDMI
signal level for short transmission length. Adjust the signal level from MIN to
MAX until desired video quality is displayed.
Recommended EQ settin ~s
Position
:able Length
[M]~
under 15m (49.5ft)
0 1
4