Owner's Manual

6
5.2 Receiver Panel
❺ ❶ ❸ ❷ ❹ ❻ ❼ ❽
Number
Name
Function description
1
HDMI Out
HDMI output port, connect to HDMI display device such as
TV or Projector with an HDMI cable.
2
CAT In
Connect to CAT Out port on the transmitter end with a
CAT6 cable.
3
Power LED (Green)
The LED will illuminate when the receiver is powered on.
Power can come from power supply or via category cable
4
Data signal
LED (Orange)
The LED will illuminate when the transmitter and the
receiver have signal transmission (link).
5
SERVICE port
For firmware update use.
6
IR In
Connect to wideband IR Receiver. The IR signal will be
transmitted to the IR Out port of the transmitter.
7
IR Out
The IR from the TX IR In will be transmitted through the
IR blaster connected here.
8
DC 12V
Plug DC 12V/1A power supply into the unit and connect
the adapter to an AC outlet.
(Note: The EXMICRO2i can be powered from either the RX
or the TX by 12V/1A power adapter, only one supply is
needed)
5.3 IR Pin Definition