Owner's Manual

5
5. Operation Controls and Functions
5.1 Transmitter Panel
❻ ❶ ❷ ❹ ❸ ❺ ❼ ❽ ❾
Number
Name
Function description
1
HDMI Out
HDMI loop output port, connect to HDMI display device such
as TV or Projector with an HDMI cable.
2
HDMI In
HDMI input port, connect to HDMI source device such as
Media server or other 4K source
3
CAT Out
Connect to CAT IN port on the receiving end with a CAT6
cable.
4
Power LED
(Green)
The LED will illuminate when the transmitter is powered on.
5
Data signal
LED (Orange)
The LED will illuminate when the transmitter and the
receiver have signal transmission (link)
6
SERVICE port
For firmware updated use.
7
IR In
Connect to IR receiver (included). The IR signal is then sent
to the IR Out to the IR Blaster at the receiver.
8
IR Out
Connect to wideband IR Blaster (included). The IR signal is
from the IR IN port of the receiver.
9
DC 12V
Plug DC 12V/1A power supply into the unit and connect the
adapter to an AC outlet.
(Note: The EXMICRO2 can be powered from either the RX
or the TX by 12V/1A power adapter, only one supply is
needed)
EDID information is copied from the display at the RX
EDID is preset to 4K @ 60Hz. Stereo
EDID is preset to 1080p Stereo
EDID is copied from the HDMI out at the TX