Owner's Manual

5 / 9
3-pin Phoenix connector for RS-232 command transmission.
The RS-232 command will pass-through from transmitter to
receiver or receiver to transmitter.
5.2 Receiver Panel
No.
Name
Function Description
1
Power LED
Red LED will be on when the receiver is powered on.
2
SERVICE port
Firmware update port.
3
DC 24V
DC 24V/1A power supply input port.
Note that the extender supports PoC function, it means that either
transmitter or receiver is powered on by 24V/1A power supply, the
other one doesn’t need power supply.
4
HDBT IN
RJ45 connector for connecting the HDBT OUT port of
transmitter with a CAT6/6a cable.
5
Connection
Signal LED
(Green)
▪ Illuminated: Transmitter and Receiver are in good
connection status.
▪ Flashing: Transmitter and Receiver are in poor connection
status.
▪ Dark: Transmitter and Receiver are not connected.
6
Data Signal
LED
(Orange)
▪ Illuminated: HDMI signal with HDCP.
▪ Flashing: HDMI signal without HDCP.
▪ Dark: No HDMI signal.
7
SPDIF OUT
SPDIF connector for optical audio output.
8
AUDIO OUT
3.5mm stereo connector for analog audio output.
RS-232
1 2
3 7 8 9 10
SERVICE
HDBT IN
SPDIF OUT AUDIO OUT HDMI OUT IR IN IR OUT
RS-232
TX RX
DC 24V
5 4 6 1211