Specifications

show qos
Chapter 7
Quality of Service Commands
92
Syntax set qos dscp-to-cos-map dscp-range cos level
Defaults The defaults are listed by the show qos command.
Access Enabled.
Examples The following command maps DSCP values 40-56 to internal CoS
value 6:
PROPMT# set qos dscp-to-cos-map 40-56 cos 6
warning: cos 5 is marked with dscp 63 which will be classified as cos 7
warning: cos 7 is marked with dscp 56 which will be classified as cos 6
As shown in this example, if the change results in a change to CoS, UNIVERGE
WL Control System displays a warning message indicating the change.
See Also
l set qos cos-to-dscp-map on page 91
l show qos on page 92
show qos
Displays the UNIVERGE WL Controller QoS settings.
Syntax show qos [default]
Defaults None.
Access Enabled.
dscp-range DSCP range. You can specify the values as decimal
numbers. Valid decimal values are 0 to 63.
To specify a range, use the following format: 40-56.
Specify the lower number first.
cos level Internal QoS value. You can specify a number from
0to7.
default Displays the default mappings.