Specifications

clear qos
Chapter 7
Quality of Service Commands
90
clear qos
Resets the UNIVERGE WL Controller mapping of Differentiated Services Code
Point (DSCP) values to internal QoS values.
The UNIVERGE WL Controller internal QoS map ensures that prioritized traffic
remains prioritized while transiting the UNIVERGE WL Controller. A
UNIVERGE WL Controller uses the QoS map to do the following:
l Classify inbound packets by mapping their DSCP values to one of eight
internal QoS values
l Classify outbound packets by marking their DSCP values based on the
UNIVERGE WL Controllers internal QoS values
Syntax clear qos
[cos-to-dscp-map [from-qos] | dscp-to-cos-map [from-dscp]]
Defaults None.
Access Enabled.
Usage To reset all mappings to their default values, use the clear qos command
without the optional parameters.
Examples The following command resets all QoS mappings:
PROPMT# clear qos
success: change accepted.
The following command resets the mapping used to classify packets with DSCP
value 44:
cos-to-dscp-map
[from-qos]
Resets the mapping between the specified internal QoS
value and the DSCP values with which UNIVERGE
WL Control System marks outbound packets.
QoS values are from 0 to 7.
dscp-to-cos-map
[from-dscp]
Resets the mapping between the specified range of
DSCP values and internal QoS value with which
UNIVERGE WL Control System classifies inbound
packets.