Specifications

show vlan config
Chapter 6
VLAN Commands
86
See Also show vlan config on page 86
show vlan config
Displays VLAN information.
Syntax show vlan config [vlan-id]
Defaults None.
Access All.
Examples The following command displays information for VLAN burgundy:
PROMPT# show vlan config burgundy
Table 11. Output for show tunnel
Field Description
VLAN VLAN name.
Local Address IP address of the local end of the tunnel. This is the
UNIVERGE WL Controller IP address where you enter the
command.
Remote Address IP address of the remote end of the tunnel. This is the system
IP address of another UNIVERGE WL Controller in the
mobility domain.
State Tunnel state:
•Up
•Dormant
Port Tunnel port ID.
LVID Local VLAN ID.
RVID Remote VLAN ID.
vlan-id VLAN name or number. If you do not specify a VLAN,
information for all VLANs is displayed.