Specifications

show tunnel
Chapter 6
VLAN Commands
85
See Also
l clear security l2-restrict on page 67
l clear security l2-restrict counters on page 68
l set security l2-restrict on page 73
show tunnel
Displays the tunnels from the UNIVERGE WL Controller where you type the
command.
Syntax show tunnel
Defaults None.
Access Enabled
Examples To display all tunnels from a UNIVERGE WL Controller to other
UNIVERGE WL Controllers in the Mobility Domain, type the following
command.
PROMPT# show tunnel
VLAN Local Address Remote Address State Port LVID RVID
---------- -------------- --------------- -------- ----- ----- -----
vlan-eng 192.168.14.2 192.168.14.4 DORMANT 1024 4096 130
Table 11 describes the fields in the display.
Permit MAC MAC addresses that clients in the VLAN are allowed to send
traffic at Layer 2.
Hits Number of packets whose source MAC address was a client
in this VLAN, and whose destination MAC address was one
of those listed under Permit MAC.
Table 10. Output for show security l2-restrict
Field Description