Specifications
show roaming vlan
Chapter 6
VLAN Commands
83
show roaming vlan
Shows all VLANs in the mobility domain, the UNIVERGE WL Controllers
servicing the VLANs, and their tunnel affinity values configured on each
UNIVERGE WL Controller for the VLANs.
Syntax
show roaming vlan
Defaults
None.
Access
Enabled.
Examples
The following command shows the current roaming VLANs:
PROMPT# show roaming vlan
VLAN Switch IP Address Affinity
----------------- ------------------- -----------
vlan-cs 192.168.14.2 5
vlan-eng 192.168.14.4 5
vlan-fin 192.168.14.2 5
vlan-it 192.168.14.4 5
vlan-it 192.168.14.2 5
vlan-pm 192.168.14.2 5
vlan-sm 192.168.14.2 5
vlan-tp 192.168.14.4 5
vlan-tp 192.168.14.2 5
Table 9 describes the fields in the display.
See Also
l show roaming station on page 81
l show vlan config on page 86
Table 9. Output for show roaming vlan
Field Description
VLAN VLAN name.
Switch IP Address System IP address of the UNIVERGE WL Controller
on which the VLAN is configured.
Affinity Preference of this UNIVERGE WL Controller for
forwarding user traffic for the VLAN. A higher
number indicates a greater preference.