Specifications

show fdb
Chapter 6
VLAN Commands
77
If more than one UNIVERGE WL Controller has the highest affinity value,
UNIVERGE WL Control System randomly selects one of the UNIVERGE WL
Controllers for the tunnel.
Examples The following command changes the VLAN affinity for VLAN beige
to 10:
PROMPT# set vlan beige tunnel-affinity 10
success: change accepted.
See Also
l show roaming vlan on page 83
l show vlan config on page 86
show fdb
Displays entries in the forwarding database.
Syntax show fdb [mac-addr-glob [vlan vlan-id]]
show fdb {permanent | static | dynamic | system | all} [port port-list |
vlan vlan-id]
mac-addr-glob A single MAC address or set of MAC addresses. Specify a
MAC address, or use the wildcard character (*) to specify a
set of MAC addresses. (For details, see “MAC Address
Globs” on page 10.)
vlan vlan-id Name or number of a VLAN for which to display entries.
permanent Displays permanent entries. A permanent entry does not age
out and remains in the database even after a reboot, reset, or
power cycle.
static Displays static entries. A static entry does not age out, but is
removed from the database after a reboot, reset, or power
cycle.
dynamic Displays dynamic entries. A dynamic entry is automatically
removed through aging or after a reboot, reset, or power
cycle.