Specifications

set port speed

Chapter 5

Port Commands

The slow throughput occurs because the side that is configured for

autonegotiation falls back to half-duplex. A stream of large packets sent to a

UNIVERGE WL Controller port with this configuration can cause forwarding on

the link to stop.

Examples

The following command disables autonegotiation on ports 1:

PROMPT# set port negotiation 1 disable

The following command enables autonegotiation on port 1:

PROMPT# set port negotiation 1 enable

set port speed

Changes the speed of a port.

Syntax

set port speed port-list {10 | 100 | 1000 | auto}

Defaults

All ports are set to auto.

Access

Enabled.

port-list List of physical ports. UNIVERGE WL Control System sets

the port speed on all the specified ports.

10 Sets the port speed of a 10/100 Ethernet port to 10 Mbps and

sets the operating mode to full-duplex.

100 Sets the port speed of a 10/100 Ethernet port to 100 Mbps

and sets the operating mode to full-duplex.

1000 Sets the port speed of a gigabit Ethernet port to 1000 Mbps

and sets the operating mode to full-duplex.

Note: This command applies only to the WL5100

auto Enables a port to detect the speed and operating mode of the

traffic on the link and set itself accordingly.