Specifications

show log trace
Chapter 23
System Log Commands
634
Defaults None.
Access Enabled.
Examples Type the following command to see the facilities for which you can
view event messages archived in the buffer:
PROPMT# show log trace facility ?
<facility name> Select one of: KERNEL, AAA, SYSLOGD, ACL, APM, ARP, ASO, BOOT,
CLI, CLUSTER, CRYPTO, DOT1X, ENCAP, ETHERNET, GATEWAY, HTTPD, IGMP, IP, MISC,
NOSE, NP, RAND, RESOLV, RIB, ROAM, ROGUE, SM, SNMPD, SPAN, STORE, SYS, TAGMGR,
TBRIDGE, TCPSSL, TELNET, TFTP, TLS, TUNNEL, VLAN, X509, XML, MP, RAPDA, WEBVIEW,
EAP, PORTCONFIG, FP.
The following command displays the newest five trace log entries for the ROGUE
facility:
PROPMT# show log trace +5 facility ROGUE
ROGUE Oct 28 16:30:19.695141 ERROR ROGUE_AP_ALERT: Xmtr Mac 01:0b:0e:ff:00:3b Ap
7 Radio 1 Chan 36 RSSI 18 Tech DOT_11A SSID univerge
ROGUE Oct 28 16:30:19.7046
37 ERROR ROGUE_AP_ALERT: Xmtr Mac 00:60:b9:11:57:co Ap 7 Radio 1 Chan 36 RSSI
15 Tech DOT_11A SSID examplewlan
ROGUE Oct 28 16:30:19.711253 ERROR ROGUE_AP_ALER
matching string Displays messages that match a string—for example, a
username or IP address.
severity severity-level Displays messages at a severity level greater than or equal
to the level specified. Specify one of the following:
• emergency—The UNIVERGE WL Controller is
unusable.
• alert—Action must be taken immediately.
• critical—You must resolve the critical conditions. If the
conditions are not resolved, the UNIVERGE WL
Controller can reboot or shut down.
• error—The UNIVERGE WL Controller is missing
data or is unable to form a connection.
• warning—A possible problem exists.
• notice—Events that potentially can cause system
problems have occurred. These are logged for
diagnostic purposes. No action is required.
• info—Informational messages only. No problem exists.
• debug—Output from debugging.