Specifications

show log buffer
Chapter 23
System Log Commands
630
Defaults Mark messages are disabled by default. When they are enabled,
UNIVERGE WL Control System generates a message at the notice level once
every 300 seconds by default.
Access Enabled.
Examples The following command enables mark messages:
PROPMT# set log mark enable
success: change accepted.
See Also show log config on page 632
show log buffer
Displays system information stored in the nonvolatile log buffer or the trace
buffer.
Syntax show log buffer [{+|-}number-of-messages] [facility facility-name]
[matching string] [severity severity-level]
buffer Displays the log messages in nonvolatile storage.
+|-number-of-messages Displays the number of messages specified as
follows:
• A positive number (for example, +100), displays
that number of log entries starting from the oldest
in the log.
• A negative number (for example, -100) displays
that number of log entries starting from newest in
the log.
facility facility-name Area of UNIVERGE WL Control System that is
sending the log message. Type a space and a question
mark (?) after show log buffer facility for a list of
valid facilities.
matching string Displays messages that match a string—for example,
a username or IP address.