Specifications

set log mark
Chapter 23
System Log Commands
629
Examples To log only emergency, alert, and critical system events to the console,
type the following command:
PROPMT# set log console severity critical enable
success: change accepted.
See Also
l show log config on page 632
l clear log on page 625
set log mark
Configures UNIVERGE WL Control System to generate mark messages at
regular intervals. The mark messages indicate the current system time and date.
NEC Networks can use the mark messages to determine the approximate time
when a system restart or other event causing a system outage occurred.
Syntax set log mark [enable | disable] [severity level]
[interval interval]
enable Enables the mark messages.
disable Disables the mark messages.
severity level Log severity at which the messages are logged:
• emergency
• alert
• critical
• error
• warning
• notice
•info
•debug
interval interval Interval at which UNIVERGE WL Control System
generates the mark messages. You can specify from 1
to 2147483647 seconds.