Specifications

System Log Commands
625
23
System Log Commands
Use the system log commands to record information for monitoring and
troubleshooting. UNIVERGE WL Control System system logs are based on
RFC 3164, which defines the log protocol.
This chapter presents system log commands alphabetically. Use the following
table to locate commands in this chapter based on their use.
clear log
Clears the log messages stored in the log buffer, or removes the configuration for
a syslog server and stops sending log messages to that server.
Syntax clear log [buffer | server ip-addr]
Defaults None.
Access Enabled.
System Logs set log on page 626
set log mark on page 629
show log buffer on page 630
show log trace on page 633
clear log on page 625
buffer Deletes the log messages stored in nonvolatile storage.
server ip-addr Deletes the configuration for and stops sending log
messages to the syslog server at this IP address. Specify an
address in dotted decimal notation.