Specifications

set port negotiation
Chapter 5
Port Commands
58
set port negotiation
Disables or reenables autonegotiation on gigabit Ethernet or 10/100 Ethernet
ports.
Syntax set port negotiation port-list {enable | disable}
Defaults Autonegotiation is enabled on all Ethernet ports by default.
Access Enabled.
Usage UNIVERGE WL Controller Ethernet ports support half-duplex and
full-duplex operation.
For a link to occur, the autonegotiation settings on a UNIVERGE WL Controller
port and the device at the other end of the link must be the same. When
autonegotiation is enabled on a UNIVERGE WL Controller port, the port
advertises support for full-duplex and half-duplex mode.
Table 5 lists the supported configurations.
port-list List of physical ports. UNIVERGE WL Control System
disables or reenables autonegotiation on all the specified
ports.
enable Enables autonegotiation on the specified ports.
disable Disables autonegotiation on the specified ports.