Specifications

set port name
Chapter 5
Port Commands
57
Usage This command is allowed only when a current port speed is 10/100Mbps
and current negotiation mode is not autonegotiation. UNIVERGE WL Controller
Ethernet ports support half-duplex and full-duplex operation.
Examples The following command sets the port duplex mode on ports 1 to half:
PROMPT# set port duplex 1 half
success: set port "1" to half
set port name
Assigns a name to a port. After naming a port, you can use the port name or
number in other CLI commands.
Syntax set port port name name
Defaults None.
Access Enabled.
Usage To simplify configuration and avoid confusion between the number of a
port and its name, it is recommended that you do not use numbers as port names.
Examples The following command sets the name of port 1 to adminpool:
PROMPT# set port 1 name adminpool
success: change accepted.
See Also
l clear port name on page 47
l show port status on page 63
port Number of a physical port. You can specify only one port.
name name Alphanumeric string of up to 16 characters, with no spaces.