Specifications

Trace Commands

605

Trace Commands

Use trace commands to perform diagnostic routines. While UNIVERGE WL

Control System allows you to run many types of traces, this chapter describes

commands for those traces you are most likely to use. For a complete listing of the

types of traces UNIVERGE WL Control System allows, type the set trace ?

command.

This chapter presents trace commands alphabetically. Use the following table to

locate commands in this chapter based on their use.

Caution! Using the set trace command can have adverse effects on system

performance. UNIVERGE WL Control System recommends that you use the

lowest levels possible for initial trace commands, and slowly increase the

levels to get the data you need.

Trace set trace sm on page 611

set trace dot1x on page 610

set trace authentication on page 607

set trace authorization on page 608

show trace on page 611

save trace on page 607

clear log trace on page 606