Specifications

show boot
Chapter 20
File Management Commands
598
Syntax show boot
Defaults None.
Access Access.
Examples The following command shows the boot information for a UNIVERGE
WL Controller:
PROMPT# show boot
Configured boot version: 6.0.2.0.003
Configured boot image: boot0:SC060200.003
Configured boot configuration: file:configuration
Backup boot configuration: file:backup.cfg
Booted version: 6.0.2.0.003
Booted image: boot0:SC060200.003
Booted configuration: file:configuration
Product model: SCA-WL10
Table 76 describes the fields in the show boot output.
Table 76. Output for show boot
Field Description
Configured boot version Software version the UNIVERGE WL Controller
will run next time the software is rebooted.
Configured boot image Boot partition and image filename UNIVERGE WL
Control System will use to boot next time the
software is rebooted.
Configured boot
configuration
Configuration filename UNIVERGE WL Control
System will use to boot next time the software is
rebooted.
Backup boot
configuration
The name of the configuration file to be used in the
event that UNIVERGE WL Control System cannot
read the configured boot configuration file next time
the software is rebooted.
Booted version Software version the UNIVERGE WL Controller is
running.