Specifications

reset system
Chapter 20
File Management Commands
591
reset system
Restarts a UNIVERGE WL Controller and reboots the software.
Syntax reset system [force]
Defaults None.
Access Enabled.
Usage If you do not use the force option, the command first compares the
running configuration to the configuration file. If the running configuration and
configuration file do not match, UNIVERGE WL Control System does not restart
the UNIVERGE WL Controller but instead displays a message advising you to
either save the configuration changes or use the force option.
Examples The following command restarts a UNIVERGE WL Controller that
does not have any unsaved configuration changes:
PROMPT# reset system
This will reset the entire system. Are you sure (y/n)y
The following commands attempt to restart a UNIVERGE WL Controller with a
running configuration that has unsaved changes, and then force the UNIVERGE
WL Controller to restart:
PROMPT# reset system
error: Cannot reset, due to unsaved configuration changes. Use "reset system
force" to override.
PROMPT# reset system force
See Also
l save config on page 594
l show boot on page 597
l show version on page 602
force Immediately restarts the system and reboots, without
comparing the running configuration to the configuration
file.