Specifications

set port
Chapter 5
Port Commands
55
Defaults None.
Access Enabled.
Examples The following command configures UNIVERGE WL Access Points 1
for UNIVERGE WL Access Points model WL1500-AP with serial-ID
G8TZUB0053:
PROMPT# set ap 1 serial-id G8TZUB0053 model WL1500-AP
success: change accepted.
The following command removes UNIVERGE WL Access Points 1:
PROMPT# clear ap 1
This will clear specified AP devices. Would you like to continue? (y/n) [n]y
See Also
l clear ap on page 45
l monitor port counters on page 47
l show port counters on page 62
l set system countrycode on page 33
set port
Administratively disables or reenables a port.
Syntax set port {enable | disable} port-list
model {WL1500-AP |
WL1500-AP-JP |
WL1700-MS(AP)}
AP model.
radiotype 11b | 11g Radio type:
• 11b—802.11b
• 11g—802.11g
enable Enables the specified ports.