Specifications

set ap

Chapter 5

Port Commands

Examples

The following command resets port 1:

PROMPT# reset port 1

See Also

set port on page 55

set ap

Configures a UNIVERGE WL Access Points, either directly connected to the

UNIVERGE WL Controller or indirectly connected through an intermediate

Layer 2 or Layer 3 network.

Syntax

set ap ap-number serial-id serial-ID

model {WL1500-AP | WL1500-AP-JP | WL1700-MS(AP)}[radiotype

{11b| 11g}]

Note. Before configuring a UNIVERGE WL Access Points, you must use the set

system countrycode command to set the IEEE 802.11 country-specific

regulations on the UNIVERGE WL Controller. See set system countrycode on

page 33.

ap-number Number for the UNIVERGE WL Access

Points.

The range of valid connection numbers

depends on the UNIVERGE WL Controller

model:

• SCA-WL10—1 to 8 (V1)

• WL5100—1 to 24 (V1)

• WL1700-MS—1 to 8

serial-id serial-ID AP serial ID. The serial ID is listed on the

UNIVERGE WL Access Points case. To

display the serial ID using the CLI, use the

show version details command.