Specifications

show rfdetect visible
Chapter 19
RF Detection Commands
575
Defaults None.
Access Enabled.
Usage If a UNIVERGE WL Access Points radio is supporting more than one
SSID, each of the corresponding BSSIDs is listed separately.
To display rogue information for the entire Mobility Domain, use the show
rfdetect mobility-domain command on the seed UNIVERGE WL Controller.
Examples To following command displays information about the rogues detected
by radio 1 on UNIVERGE WL Access Points 3:
PROPMT# show rfdetect visible ap 3 radio 1
Total number of entries: 104
Flags: i = infrastructure, a = ad-hoc
c = CCMP, t = TKIP, 1 = 104-bit WEP, 4 = 40-bit WEP, w = WEP(non-WPA)
Transmit MAC Vendor Type Ch RSSI Flags SSID
----------------- ------- ----- --- ---- ------ --------------------------------
00:07:50:d5:cc:91 Cisco intfr 6 -60 i----w r27-cisco1200-2
00:07:50:d5:dc:78 Cisco intfr 6 -82 i----w r116-cisco1200-2
00:09:b7:7b:8a:54 Cisco intfr 2 -54 i-----
00:0a:5e:4b:4a:c0 3Com intfr 11 -57 i----- public
00:0a:5e:4b:4a:c2 3Com intfr 11 -86 i-t1-- univergewlan
00:0a:5e:4b:4a:c4 3Com intfr 11 -85 ic---- unvg-ccmp
00:0a:5e:4b:4a:c6 3Com intfr 11 -85 i-t--- unvg-tkip
00:0a:5e:4b:4a:c8 3Com intfr 11 -83 i----w unvg-voip
00:0a:5e:4b:4a:ca 3Com intfr 11 -85 i----- unvg-webaaa
...