Specifications

show rfdetect visible
Chapter 19
RF Detection Commands
574
Syntax show rfdetect vendor-list
Defaults None.
Access Enabled.
Examples The following example shows the permitted vendor list on
UNIVERGE WL Controller:
PROPMT# show rfdetect vendor-list
Total number of entries: 1
OUI Type
----------------- ------
aa:bb:cc:00:00:00 client
11:22:33:00:00:00 client
See Also
l clear rfdetect vendor-list on page 550
l set rfdetect vendor-list on page 558
show rfdetect visible
Displays the BSSIDs discovered by a specific UNIVERGE WL Access Points
radio.
Syntax show rfdetect visible mac-addr
Syntax show rfdetect visible ap ap-number [radio {1 | 2}]
mac-addr Base MAC address of the UNIVERGE WL Access Points
radio.
Note: To display the base MAC address of a UNIVERGE
WL Access Points radio, use the show ap status command.
ap-number Number of a UNIVERGE WL Access Points for which to
display neighboring BSSIDs.
radio 1 Shows neighbor information for radio 1.
radio 2 Shows neighbor information for radio 2. (This option does
not apply to single-radio models.)