Specifications

set rfdetect signature
Chapter 19
RF Detection Commands
556
Usage The log messages for rogues are generated only on the seed and appear
only in the seed’s log message buffer. Use the show log buffer command to
display the messages in the seed UNIVERGE WL Controllers log message buffer.
Examples The following command enables RF detection logging for the Mobility
Domain managed by this seed UNIVERGE WL Controller:
Controller# set rfdetect log enable
success: rfdetect logging is enabled.
See Also show log buffer on page 630
set rfdetect signature
Enables UNIVERGE WL Access Points signatures. A UNIVERGE WL Access
Point signature is a set of bits in a management frame sent by a UNIVERGE WL
Access Point that identifies that UNIVERGE WL Access Points to UNIVERGE
WL Control System. If someone attempts to spoof management packets from a
UNIVERGE WL Access Points, UNIVERGE WL Control System can detect the
spoof attempt.
Syntax set rfdetect signature {enable | disable}
Defaults UNIVERGE WL Access Points signatures are disabled by default.
Access Enabled.
Usage The command applies only to UNIVERGE WL Access Points managed
by the UNIVERGE WL Controller on which you enter the command. To enable
signatures on all UNIVERGE WL Access Points in a Mobility Domain, enter the
command on each UNIVERGE WL Controller in the Mobility Domain.
enable Enables UNIVERGE WL Access Points signatures.
disable Disables UNIVERGE WL Access Points signatures.
Note. You must use the same UNIVERGE WL Access Points signature setting
(enabled or disabled) on all UNIVERGE WL Controllers in a Mobility Domain.