Specifications

set rfdetect ignore
Chapter 19
RF Detection Commands
554
Defaults The client black list is empty by default.
Access Enabled.
Usage In addition to manually configured entries, the list can contain entries
added by UNIVERGE WL Control System. UNIVERGE WL Control System can
place a client in the black list due to an association, reassociation or disassociation
flood from the client.
The client black list applies only to the UNIVERGE WL Controller on which the
list is configured. UNIVERGE WL Controllers do not share client black lists.
Examples The following command adds client MAC address 11:22:33:44:55:66
to the black list:
PROPMT# set rfdetect black-list 11:22:33:44:55:66
success: MAC 11:22:33:44:55:66 is now blacklisted.
See Also
l set rfdetect black-list on page 553
l show rfdetect black-list on page 559
set rfdetect ignore
Configures a list of known devices to ignore during an RF scan. UNIVERGE WL
Control System does not generate log messages or traps for the devices in the
ignore list.
Syntax set rfdetect ignore mac-addr
Defaults UNIVERGE WL Control System reports all non-UNIVERGE WL
Control System BSSIDs detected during an RF scan.
Access Enabled.
mac-addr BSSID (MAC address) of the device to ignore.