Specifications

set rfdetect attack-list
Chapter 19
RF Detection Commands
552
Examples The following command tests the RF link between the UNIVERGE
WL Controller and the client with MAC address 00:60:b9:11:ad:13:
PROPMT# rfping mac 00:60:b9:11:ad:13
RF-Link Test to 00:60:b9:11:ad:13 :
Session-Id: 2
Packets Sent Packets Rcvd RSSI SNR RTT (micro-secs)
------------ ------------ ------- ----- ----------------
20 20 -68 26 976
Table 67 describes the fields in this display.
See Also
l show rfdetect data on page 566
l show rfdetect visible on page 574
set rfdetect attack-list
Adds an entry to the attack list. The attack list specifies the MAC addresses of
devices that UNIVERGE WL Control System should issue countermeasures
against whenever the devices are detected on the network. The attack list can
contain the MAC addresses of APs and clients.
Table 67. rfping Output
Field Description
Packets Sent The number of test packets sent from the UNIVERGE WL
Controller to the client.
Packets Rcvd The number of test packets acknowledged by the client.
RSSI Received signal strength indication (RSSI)—the strength of the
RF signal from the client, in decibels referred to 1 milliwatt
(dBm).
SNR Signal-to-noise ratio (SNR), in decibels (dB), of the data received
from the client.
RTT (micro-secs) The round-trip time, in microseconds, for the client response to
the test packets.