Specifications

rfping
Chapter 19
RF Detection Commands
551
Syntax clear rfdetect vendor-list {client mac-addr | all}
Defaults None.
Access Enabled.
Examples The following command removes client OUI aa:bb:cc:00:00:00 from
the permitted vendor list:
PROPMT# clear rfdetect vendor-list client aa:bb:cc:00:00:00
success: aa:bb:cc:00:00:00 is no longer in client vendor-list.
See Also
l set rfdetect vendor-list on page 558
l show rfdetect vendor-list on page 573
rfping
Provides information about the RF link between the UNIVERGE WL Controller
and the client based on sending test packets to the client.
Syntax rfping {mac mac-addr | session-id session-id}
Defaults None.
Access Enabled.
Usage Use this command to send test packets to a specified client. The output of
the command indicates the number of test packets received and acknowledged by
the client, as well as the client’s signal strength and signal-to-noise ratio.
client | ap Specifies whether the entry is for an AP brand or a client
brand.
mac-addr | all Organizationally Unique Identifier (OUI) to remove.
mac-addr Tests the RF link between the UNIVERGE WL Controller
and the client with the specified MAC address.
session-id Tests the RF link between the UNIVERGE WL Controller
and the client with the specified local session ID.