Specifications

clear sessions network
Chapter 18
Session Management Commands
532
Defaults None.
Access Enabled.
Examples To clear all administrator sessions type the following command:
PROPMT# clear sessions admin
This will terminate manager sessions, do you wish to continue? (y|n) [n]y
To clear all administrative sessions through the console, type the following
command:
PROPMT# clear sessions console
This will terminate manager sessions, do you wish to continue? (y|n) [n]y
To clear all administrative Telnet sessions, type the following command:
PROPMT# clear sessions telnet
This will terminate manager sessions, do you wish to continue? (y|n) [n]y
To clear Telnet client session 0, type the following command:
PROPMT# clear sessions telnet client 0
See Also show sessions on page 534
clear sessions network
Clears all network sessions for a specified username or set of usernames, MAC
address or set of MAC addresses, virtual LAN (VLAN) or set of VLANs, or
session ID.
telnet Clears sessions for all users with administrative access to
the UNIVERGE WL Controller through a Telnet
connection.
telnet client
[session-id]
Clears all Telnet client sessions from the CLI to remote
devices, or clears an individual session identified by
session ID.
mesh-ap
[session-id]
Note: This parameter is not supported.