Specifications

set dot1x wep-rekey
Chapter 17
802.1X Management Commands
525
success: dot1x tx-period set to 300.
See Also
l clear dot1x tx-period on page 518
l show dot1x on page 526
set dot1x wep-rekey
Enables or disables Wired Equivalency Privacy (WEP) rekeying for broadcast and
multicast encryption keys.
Syntax set dot1X wep-rekey {enable | disable}
Defaults WEP key rotation is enabled, by default.
Access Enabled.
Usage Reauthentication is not required for WEP key rotation to take place.
Broadcast and multicast keys are always rotated at the same time, so all members
of a given radio, VLAN, or encryption type receive the new keys at the same time.
Examples Type the following command to disable WEP key rotation:
PROMPT# set dot1x wep-rekey disable
success: wep rekeying disabled
See Also
l set dot1x wep-rekey-period on page 526
l show dot1x on page 526
enable Causes the broadcast and multicast keys for WEP to be
rotated at an interval set by the set dot1x wep-rekey-period
for each radio, associated VLAN, and encryption type. The
UNIVERGE WL Controller generates the new broadcast
and multicast keys and pushes the keys to the clients via
EAPoL key messages.
disable WEP broadcast and multicast keys are never rotated.