Specifications

set dot1x timeout supplicant
Chapter 17
802.1X Management Commands
524
set dot1x timeout supplicant
Sets the number of seconds that must elapse before the UNIVERGE WL
Controller times out an authentication session with a supplicant (client).
Syntax set dot1x timeout supplicant seconds
Defaults The default is 30 seconds.
Access Enabled.
Examples Type the following command to set the number of seconds for
authentication session timeout to 300:
PROMPT# set dot1x timeout supplicant 300
success: dot1x supplicant timeout set to 300.
See Also
l clear dot1x timeout auth-server on page 517
l show dot1x on page 526
set dot1x tx-period
Sets the number of seconds that must elapse before the UNIVERGE WL
Controller retransmits an EAPoL packet.
Syntax set dot1x tx-period seconds
Defaults The default is 5 seconds.
Access Enabled.
Examples Type the following command to set the number of seconds before the
UNIVERGE WL Controller retransmits an EAPoL packet to 300:
PROMPT# set dot1x tx-period 300
seconds Specify a value between 1 and 65,535.
seconds Specify a value between 1 and 65,535.