Specifications

set dot1x max-req
Chapter 17
802.1X Management Commands
520
Examples Type the following command to enable key transmission:
PROMPT# set dot1x key-tx enable
success: dot1x key transmission enabled.
See Also show dot1x on page 526
set dot1x max-req
Sets the maximum number of times the UNIVERGE WL Controller retransmits
an EAP request to a supplicant (client) before ending the authentication session.
Syntax set dot1x max-req number-of-retransmissions
Defaults The default number of EAP retransmissions is 2.
Access Enabled.
Usage To support SSIDs that have both 802.1X and static WEP clients,
UNIVERGE WL Control System sends a maximum of two ID requests, even if
this parameter is set to a higher value. Setting the parameter to a higher value does
affect all other types of EAP messages.
Examples Type the following command to set the maximum number of EAP
request retransmissions to three attempts:
PROMPT# set dot1x max-req 3
success: dot1x max request set to 3.
See Also
l clear dot1x max-req on page 515
l show dot1x on page 526
set dot1x quiet-period
Sets the number of seconds a UNIVERGE WL Controller remains quiet and does
not respond to a supplicant after a failed authentication.
number-of-retransmissions Specify a value between 0 and 10.