Specifications

set dot1x key-tx
Chapter 17
802.1X Management Commands
519
Usage Normally, the Bonded Auth period needs to be set only if the network has
Bonded Auth clients that use dynamic WEP, or use WEP-40 or WEP-104
encryption with WPA or RSN. These clients can be affected by the 802.1X
reauthentication parameter or the RADIUS Session-Timeout parameter.
UNIVERGE WL Control System recommends that you try 60 seconds, and
change the period to a longer value only if clients are unable to authenticate within
60 seconds.
The bonded authentication period applies only to 802.1X authentication rules that
contain the bonded option.
Examples To set the bonded authentication period to 60 seconds, type the
following command:
PROMPT# set dot1x bonded-period 60
success: change accepted.
See Also
l clear dot1x bonded-period on page 514
l show dot1x on page 526
set dot1x key-tx
Enables or disables the transmission of encryption key information to the
supplicant (client) in EAP over LAN (EAPoL) key messages, after authentication
is successful.
Syntax set dot1x key-tx {enable | disable}
Defaults Key transmission is enabled by default.
Access Enabled.
enable Enables transmission of encryption key information to
clients.
disable Disables transmission of encryption key information to
clients.