Specifications

clear dot1x timeout auth-server
Chapter 17
802.1X Management Commands
517
clear dot1x timeout auth-server
Resets to the default setting the number of seconds that must elapse before the
UNIVERGE WL Controller times out a request to a RADIUS server.
Syntax clear dot1x timeout auth-server
Defaults The default is 30 seconds.
Access Enabled.
Examples To reset the default timeout for requests to an authentication server,
type the following command:
PROMPT# clear dot1x timeout auth-server
success: change accepted.
See Also
l set dot1x timeout auth-server on page 523
l show dot1x on page 526
clear dot1x timeout supplicant
Resets to the default setting the number of seconds that must elapse before the
UNIVERGE WL Controller times out an authentication session with a supplicant
(client).
Syntax clear dot1x timeout supplicant
Defaults The default for the authentication timeout sessions is 30 seconds.
Access Enabled.
Examples Type the following command to reset the timeout period for an
authentication session:
PROMPT# clear dot1x timeout supplicant
success: change accepted.
See Also
l set dot1x timeout supplicant on page 524
l show dot1x on page 526