Specifications

802.1X Management Commands
513
17
802.1X Management
Commands
Use 802. IEEE X management commands to modify the default settings for IEEE
802.1X sessions on a UNIVERGE WL Controller. For best results, change the
settings only if you are aware of a problem with 802.1X performance on the
UNIVERGE WL Controllers.
This chapter presents 802.1X commands alphabetically. Use the following table
to locate commands in this chapter based on their use. For information about
configuring 802.1X commands for user authentication, see Chapter 9, “AAA
Commands,” on page 183.
Caution! 802.1X parameter settings are global for all SSIDs configured on
the UNIVERGE WL Controller.
set dot1x bonded-period on page 518
Keys set dot1x key-tx on page 519
set dot1x tx-period on page 524
clear dot1x tx-period on page 518
set dot1x wep-rekey on page 525
set dot1x wep-rekey-period on page 526
Bonded Authentication clear dot1x bonded-period on page 514
set dot1x bonded-period on page 518
Reauthentication set dot1x reauth on page 521
set dot1x reauth-max on page 522
clear dot1x reauth-max on page 516